- Solid Wood
- >
- Sanders
- >
- Widebelt Sander
- >
- Used TIMESAVER MODEL 2331-04-334 2 HEAD ORBITAL SANDER 43" WideBelt Sander-Year 2004-sold
Used TIMESAVER MODEL 2331-04-334 2 HEAD ORBITAL SANDER 43" WideBelt Sander-Year 2004-sold
Timesavers 2331-04-334 Orbital Sander is equipped
with two dual motion, single pad orbital heads followed by a
10” diameter abrasive brush
Abrasive size (orbital heads): 43” x 12-1/2”
Abrasive size (abrasive brush): 10” diameter
Main motors: 5, 5, 2 HP TEFC
Maximum width stock: 42”
Maximum thickness opening: 5”
Infeed loading area: 24”
Feed speed: 5-20 FPM
Voltage: 230/3/60
Motor type: TEFC
Passline height: 33” - 38”
Dust extraction: 3,100 CFM (5” static pressure)
Compressed air usage: 4 CFM @ 90 psi
Approximate shipping weight: 5,400 lbs.
Single Pad, Dual Motion Orbital Head: (1st & 2nd heads)
Each 7” wide dual motion orbital pad is powered by a 5 HP
main drive motor.
❑ 10” Diameter Brush Head: (third head position)
Abrasive brush in third head position powered by a 2 HP main
drive motor. Provides edge break on parts as well as opens
grain to allow stain penetration. (180 grit slashed abrasive)
❑ Dual Infeed and Dual Outfeed Holddown Rolls:
Rubber-covered, spring loaded rolls aid in holding parts onto
the conveyor as they pass through the machine.
❑ Variable Speed Conveyor Drive:
5-20 FPM A/C variable frequency conveyor drive allows
operator to easily change feed speed by turning a dial, even
while parts are running.
❑ Centralized Control Panel:
Simple operator controls for machine operation. Conveyor
feed, conveyor speed, orbital head and abrasive brush head are
controlled at this centralized control panel.
❑ Four Jack Bed Construction:
Four heavy-duty precision bed jacks, one supporting each
corner of the conveyor bed.
❑ Hour Meter:
Records actual running time of the machine. This unit is used
by maintenance for scheduled lubrication of key components.
Series 2300 Orbital
Orbital Head
3
❑ Quick Change Abrasive:
A unique system utilizing a tension fit rail and abrasive paper
assembly. Allows for fast abrasive changeover.
(Patent Pending)
❑ Infeed Stop Bar:
A sheet metal gate acts as an emergency stop for the operator
when loading the machine. The gate actuates a limit switch,
which shuts down the abrasive heads and conveyor in
emergency situation.
❑ Electronic Go-To Device:
Allows user to digitally enter desired machine opening position.
Indicates conveyor speed and conveyor bed position in relation
to sanding belt for accurate setup to .001”. The device can store
up to ten programs.
❑ Infeed Conveyor Extension:
Large 24” infeed conveyor extension for staging parts to aid in
loading machine.
❑ U.L. Listed Components:
Includes main motor fusing, electrical disconnect, A/L magnetic
starters and 110 volt control circuit.
❑ Vacuum Conveyor Bed:
Allows small parts (6” x 4”) to be processed. Provides positive
feeding of small parts as they pass through the machine. Parts
must have a surface smooth enough to seal to the conveyor belt.
- FOB: OK AS is Where is.
- Loaded on Truck